Huawei S5700-28C-SI Installation Guide download pdf (Page 64)

Networking Requirements

As shown in Figure 5-5, SwitchA is newly added to the network. SwitchA and SwitchB are

connected through a trunk link. To enable the network administrator to manage SwitchA

remotely, you need to configure the Telnet service and set the device name on SwitchA.

Figure 5-5 Networking diagram of managing SwitchA through Telnet

RS-232

Console cable

Console port

PC SwitchA

serial port

Ethernet

administrator

SwitchB

GE 0/0/1

Configuration Roadmap

The configuration roadmap is as follows:

1. Log in to SwitchA through the console interface.

2. Set the device name.

3. Configure a management VLAN.

4. On SwitchA, set the type of the interface that connects SwitchA and SwitchB to trunk. Add

the interface to the management VLAN in trunk mode.

5. Configure the management IP address of SwitchA.

6. Configure the Telnet service.

Data Preparation

To complete the configuration, you need the following data:

l ID of the management VLAN

l Management IP address of SwitchA

l Number of the interface that connects SwitchA and SwitchB on SwitchA

l Authentication mode, user name, and password

Configuration Procedure

1. Log in to SwitchA through the console port. For details, see Logging In to the Switch

Through the Console Interface.

S3700&S5700&S6700 Series Ethernet Switches

Quick Start 5 Logging in to the Device

Issue 02 (2012-09-10) Huawei Proprietary and Confidential

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 70

No comments

Huawei S5700-28C-SI Installation Guide Page 64